Using a hand held Atomizer (sprayer), preferably air compression in
design, spray a mist of EVICTOR SOLUTION on the horizontal and vertical
surface of the linen stripped mattress, box spring and headboard of the
beds. Using the same procedure spray the furniture in the room with the
same type mist, the objective being that of promoting death to the bed
bugs, mites and fleas at large. Roll back any seams or material tucks of
the mattress or box spring and liberally treat those areas with
additional spray. Remove the cushions from any furniture and treat the
bottom sides and the cushions wells. Chairs with cloth cushions should
be treated on the bottom side as well as the top.
Using a compression type sprayer dispersing a fine mist of solution
spray each and every square inch of horizontal floor surface including
but not limited to the carpet, tile and wood floor areas. Spray the mop
boards first and any drapes and curtains to at least 24 inches from the
floor. Work backward from the farthest point of the room making sure a
liberal amount of the solution is being applied to all areas. It is
imperative that no area be left untreated. Spray the legs of all
furniture and any lamp posts or other vertical supports. Treat any and
all cupboard or vanity areas with a light spray.
EVICTOR is a contact killer
as well as a pheromone interruption agent. It is also a penetrant and
will erode the insect egg and larvae by promoting de-hydration.
The use of approximately 1 gallon of solution is required to
satisfactorily treat a 1000 square foot room. 1 gallon per 1000 square
foot of surface area is normally required to conduct a satisfactory
control or preventative maintenance treatment.